Previously: A boy learns about flying objects…
I got my package with my new dji Phantom, but my camera was still finding its way to me.
Meanwhile I learned the basics of the drone, it’s feature, the controls, GPS, propellers, etc.
Before my drone will be able to fly for the first time, I was about to make any possible mistake in the book…
First, I plugged the battery pack to the included balanced charger, just to learn a few hours later that I didn’t plug the smaller plug to the charger, so 3 hours wasted already.
Next, I had to update the firmware on it, but it can’t run on a Mac and my Windows 8.1 desktop didn’t allow it to install due to drivers signing issues, so I had to reboot Windows into a special mode that skips the drivers signature check…. Did I mentioned it took me 5 times of install and remove to figure this out.
Finally I was able to update the firmware and was ready to try my first flight.
Reading on the web how stupid it is to fly it indoors, I decided to start in my backyard. When you live in Arizona, saying backyard is like saying a pool… So my backyard area is very tight… In addition I have this huge tree that is great to block the desert’s sun, here in the valley of the sun… Guess what else will be blocked by my lovely tree? GPS Signal!
Yes, my first flight was in an area that had a tree on one side, a pool on the other side and walls and windows on all the other sides, plus some columns, cause how else will the patio’s roof will stand in place???
But wait, there is more….
I found a nice spot, far enough from the pool, the tree and the house, and was ready to kick off the engines by setting the joysticks into one of the “on” sequences …
The rotors start spinning, I push the left stick up to see some elevation for the first time, and …. Nothing, as if my drone refuse to take off. The farther I push the stick, the louder it gets and it feels like it has fear of heights and it just holds to the ground as hard as it can…
After a few attempts it hit me…. What other mistake could I possibly make? Of course, I reversed the propellers and put the CW on the CCW motors, and the CCW on the CW motors, making sure my drone will try to fly INTO the ground.
As I was back at my desk swapping propellers around, I remembered how surprised I was while installing them for the first time of the amount of force it took to screw them in!!!
Ok, now I think I’m ready to fly it again, but not before I’ll have to recharge the battery! This Time I made sure I didn’t forget to plug the little connector to the charger….